1. Error scenario: If the material box is not connected, that is, in monochrome printing, the material break detection switch is turned on. When the extruder material break detection switch does not detect the consumables, a pop-up window alarm will be displayed.
S2.5 Allen key*1
If the ACE Pro is not connected, that is, in monochrome printing mode, and the material end detection function is turned on at the same time, when the material end detection switch does not detect consumables, a pop-up alarm will be prompted.
1. The filament needs to be manually fed into the extruder. The filament needs to be fed into the print head and pushed into the extruder.
2. Click the "Extrude" function on the touch screen. When the temperature reaches the limit, you can push the filament into the extruder and observe whether the filament is fed into the extruder and whether it is extruded smoothly from the nozzle.
If no filament is squeezed out of the nozzle in step 1, check whether the inlet is blocked. You can refer to step 2 to troubleshoot the problem.
1. Check if the hub inlet is blocked and remove the fixing screws with an S2.0 Allen key.
3. If there is a blockage, pull the extruder handle to the right and pull out the filament at the same time.
4. After cleaning, reinstall the hub on top of the print head and tighten the fixing screws with an S2.5 Allen key.