¶ Tips:
You need to turn off the power and remove the power cord when checking the motherboard wiring harness and accelerometer wiring.
¶ 1. Tools :
S2.5 Allen key
Slotted wrench
¶ 2. Check the Y-axis accelerometer connection line:
¶ Step 1: Check the hot bed connection line
Check whether the accelerometer connection line at the bottom of the hot bed is detached.
(Note: You need to turn off the power and remove the power cord when checking the accelerometer connection.)
1. Use a flat-blade wrench to open the cover.
2.Reseat the accelerometer module wiring. (Note: You need to disconnect the power cord and remove it when checking the accelerometer wiring.)
After checking the accelerometer wiring is complete, reinstall the bottom cover in place.
¶ Step 2: Remove the bottom plate
Use an S2.5 Allen key to remove the two screws that secure the bottom plate. (Note: You need to turn off the power and remove the power cord when checking the motherboard harness.)
¶ Step 3: Check the Y-axis accelerometer cable on the motherboard
Pull the accelerometer cable on the motherboard gently to check if it is loose. (Note: You need to turn off the power and remove the power cord when checking the motherboard harness.)
¶ 3.Tips:
You can start the machine to test printing after installing the motherboard bottom cover. Please do not start the machine without installing the motherboard bottom cover.