The Y-axis Accelerometer gyroscope moduler is located at the rear of the heated bed, behind the offset measurement switch.
S2.0 Allen Key
S2.5 Allen Key
Troubleshooting Steps:
Before troubleshooting, make sure to turn off the printer and disconnect the power for safety.
Tilt the printer so that its bottom faces you.
① Use the S2.5 Allen Key to loosen the 4 screws fixing the mainboard bottom cover.
② Disconnect the FAN2 fan cable on the mainboard and place the mainboard bottom cover aside.
Replug the cables at both ends of the sensor, and interface.
Note: If there is glue on the appearance, gently tear off the glue before unplugging the cables.
Troubleshooting Steps:
Use the S2.0 Allen Key to unscrew the 2 screws fixing the sensor adapter board and remove the adapter board.
Carefully inspect both sides of the sensor adapter board, observe if there are breakdowns, burns, or any soldering issues with the PINs.
If you encounter any problems, take photos of the sensor adapter board and create an after-sales ticket to provide it to the after-sales engineer.
The after-sales engineers will assist you in finding a solution to the problem(Reply time :1 working day)
Please click this link to submit your ticket: