¶ 1. Tools:
S2.5 Allen Key
Flathead Screwdriver
¶ 2. Disassembly Steps:
¶ Step 1: Turn off the 3D Printer
Before replacing the WiFi antenna, make sure to turn off the 3D printer and disconnect the power for safety.
¶ Step 2: Remove the Control Screen Cable
Hold the sides of the control screen cable connector and detach it. Then, remove the cable from the cable groove.
¶ Step 3: Disassemble the Base Plastic Parts
① Use the S2.5 Allen Key to unscrew the 2 screws securing the bottom plastic part.
② Use the flathead screwdriver to pry open the plastic part.
③ Take out the control screen cable from the plastic part.
④ Disconnect the FAN2 fan wire from the mainboard and set the plastic part aside.
¶ Step 4: Remove the WiFi Antenna
Since the Kobra 2 Pro WiFi antenna is attached inside the mainboard casing,
peel off the WiFi antenna sticker, carefully unplug the WiFi cable connector from the mainboard, and remove the entire WiFi antenna.
|
|