¶ 1.Caution:
Note: When replacing the extruder, perform filament retraction for the print head. Wait for the print head to cool down before proceeding with the replacement.
¶ 2.Tools：
- M2.5 hex key
¶ 3.Disassembly Steps：
¶ Step 1: Turn off the printer
Before proceeding with the replacement, make sure to turn off the printer and disconnect the power to ensure safe operations.
¶ Step 2: Disconnect Module Wiring
Move the cable clip upward, pry open the clip, and disconnect the print head module's wiring by gently pulling it out.
Remove the clip on the quick connector, press the quick connector, and pull out the filament tube.
¶ Step 3: Disassemble the Print Head Module
Use an M2.5 Allen key to remove the screws securing the print head.
¶ 4. Installation Steps:
¶ Step 1: Replace the Print Head
Use an M2.5 Allen key to install and secure the print head in place.
¶ Step 2: Connect the Print Head Wiring
Remove the clip at the quick connector of the new print head, connect the filament tube, and reinstall the clip.
Align the print head wiring with the cable port, then press it into the cable port, and finally, install the cable clip.
Tip: After replacement, please level your printer.
If the above steps do not provide assistance or if you encounter any other issues during subsequent use, we recommend that you create a support ticket.
The after-sales engineers will assist you in finding a solution to the problem(Reply time :1 working day)
Please click this link to submit your ticket:
After-sales Ticket Submission Page