¶ 1.Tools：
- S2.0 Allen Key
- S2.5 Allen Key
¶ 2.Disassembly Steps:
¶ Step 1: Turn Off the Printer
Before replacing any parts, turn off the printer and disconnect the power supply to ensure safe operation.
¶ Step 2: Turn Off ACE Pro
Unplug the ACE Pro signal and power cables, then remove the PTFE tube.
¶ Step 3: Disassemble the ACE Pro Outer Shell
1.Use the S2.0 allen key to unscrew the four screws securing the ACE Pro signal input board and the buffer mechanism.
2.Use the S2.0 allen key to unscrew the two screws securing the cover plate, then remove the cover plate.
3.Peel off the foot pads and use the S2.5 allen key to unscrew the six screws securing the ACE Pro inner shell.
¶ Step 4: Separate the ACE Pro Inner Shell
Use the S2.5 allen key to unscrew the two screws securing the multicolor outer shell, then separate the inner and outer shells of the ACE Pro.
¶ Step 5: Disassemble the ACE Pro Motor
1.Use the S2.5 allen key to unscrew the screws securing the motor bracket, then remove the motor bracket from the belt.
2.Use the S2.5 allen key to unscrew the screws securing the motor.
¶ 3.Installation Steps:
¶ Step 1: Installing the New Motor
1.Replace the old motor with the new one, then use the S2.5 Allen key to tighten the screws securing the motor.
2.Install the motor bracket onto the ACE Pro inner shell, then use the S2.5 Allen key to tighten the screws securing the bracket.
¶ Step 2: Install the ACE Pro Inner Shell
Install the multicolor panel, then use the S2.5 Allen key to tighten the two screws securing the multicolor panel.
¶ Step 3: Secure the ACE Pro Outer Shell
1.Use the S2.0 Allen key to tighten the two screws securing the cover plate.
2.Use the S2.5 Allen key to tighten the screws securing the outer shell, then affix the foot pads.
¶ Step 4: Connect ACE Pro and the Printer
Install the PTFE tube, then plug the ACE Pro signal cable and power cable back into their respective interfaces.