Before installation, turn off the printer and disconnect the power to ensure safe operation.
The camera needs to be mounted on the bracket. You can either print the model below or design your own bracket model.
1. Remove the camera cover and install the camera.
2. Connect the camera cable and install the rear cover of the bracket.
3. Assemble the camera bracket.
Install the camera bracket on the X axis, align it with the screw hole, and tighten the screw securing the bracket using a Phillips screwdriver(M3x8 self-tapping screw)
Connect the camera to the USB port of the printer.
Note: There are two USB ports on the printer, and the camera can only be connected to the left port.
After the printer is powered on, if the camera icon is displayed in the upper right corner of the page, the printer is successfully installed.
Please bind the printer according to the following document first, and then click the button in the red box below from the APP to turn on the LED light.
Please check that the LED light on the camera is turned on. If the LED light is not turned on, you need to check whether the camera cable is loose, whether the network connection is normal, and then try to turn on the LED light again.