The Kobra 3 Combo printer has been calibrated before leaving the factory. After completing the operation according to the novice guide function of the machine, it can print directly. If the machine is abnormal due to transportation reasons, we may need to manually calibrate it to ensure that the printer is working properly.
H10 Wrench*1
S2.5 Allen key*1
S3.0 Allen key*1
Feed tray*1
Check if the print head module is loose, as shown in the figure.
1. If the print head module is loose, please refer to the following steps to adjust it.
Use H10 Wrench to adjust the eccentric column of the print head module.
2. Make sure all bearing wheels are in contact on both sides of the double-axis core without any shaking.
3. Check that the X-axis bearing wheel can move smoothly on the double-axis core.