S1.5 Allen key*1
S2.0 Allen key*1
S2.5 Allen key*1
Remove all consumables and wait for the hot bed and print head to cool down to below 50 degrees before turning off the power.
Please put the power cord and signal cord in the pearl cotton.
1. Please use S1.5 Allen key to remove the fixing screws of the print head cable (orange Type-C long cable), put the screws into bag No. 1, press the X-axis cable buckle and pull it down, wrap the X-axis cable and the print head cable together and place them under the hot bed.
2. Remove the Teflon tube from the hub. Press the buckle (1) and pull the Teflon tube upwards (2).
3. Please use S2.5 Allen key to remove the fixing screws of the print head module, put the screws into bag No. 2, and the pearl cotton inside the print head module.
4. Use your hand to pull the belt above the Z axis to the right to raise the Z axis to the top.