Tip: To facilitate the replacement of the X-axis motor, you can first raise the X-axis aluminum profile.
¶ 1. Required tools
●S2.0 Allen key
●S2.5 Allen key
¶ 2. Disassembly steps:
¶ Step 1: Turn off the printer
Before replacing the nozzle wipe silicone assembly, make sure to turn off the printer and disconnect the power supply to ensure safe operation.
¶ Step 2: Disassemble the X-axis motor housing
① Unplug the wiring plug connected to the motor.
② Use the S2.0 Allen key to unscrew the screws that fix the housing and remove the housing.
¶ Step 3: Disassemble the motor
Use the S2.0 Allen key to unscrew the four screws that fix the motor and remove the X-axis motor.
¶ 2. Installation steps
¶ Step 1: Replace the X-axis motor
① Take out the new X-axis motor and pass the motor synchronous wheel through the X-axis belt.
② Use the S2.5 Allen key to install and fix the X-axis motor.
¶ Step 2: Install the motor housing
① Install the housing back to the X-axis aluminum profile and use an S2.0 Allen key to install and fix it.
② Connect the wiring plug connected to the motor back to the X-axis motor port.
Note: After the replacement is completed, please re-level the hot bed before printing.