¶ Step 1: Remove the ACE Pro teflon tube
The ACE Pro teflon tube is at the rear of the machine, and the blue clasp should be removed. Press the clasp and pull the teflon tube out. The blue clasp should be stuck to the buffer mechanism again.
¶ Step 2: Remove the ACE Pro power cord and signal cable
Remove the ACE Pro signal cable and power cord, then put them and the cable card into the resonance film bubble bag, and then seal the bubble bag.
¶ Step 3: Pack ACE Pro accessories
Place the packed kit inside the ACE Pro and place the teflon tube on top of the kit.
¶ Step 4: Pack ACE Pro
Insert the pearl cotton from the left and right sides of the ACE Pro, then place it in the carton, and finally seal the box with tape.
