¶ Tip：
Applicable to the Kobra 3 Max (without ACE Pro)stand-alone version print head cable fixation. In order to prevent the Teflon tube and print head cable from sagging during printing and affecting the movement of the print head, and to avoid wear of the print head cable, you can install the print cable fixing parts
¶ Accessories List
¶ Installation Process
¶ 1. Install the print head fixture
First install the orange print head cable into the groove of the fixing part, and then clamp the
Teflon tube into the groove of the fixing part.
Fix the print head cable on the right side, then install the Teflon tube along the groove, and press the fixing piece and the inlet and outlet components to fix them.
¶ 2. Install the Hub
Replace the original hub with the print hub and install it into the card slot
¶ 3. Fix the cables and Teflon tubes
Insert the other end of the Teflon tube into the hub slot
Then install and fix the print head cable, and press the hub groove and the print head cable fixing ring tightly.
Arrange the wires and fix the print head cable and Teflon tube to the wire card slots respectively.
After installation, the print head cable and Teflon tube will not sag and affect printing.