¶ 1. Tools:
- S1.5 Allen key
- S2.5 Allen key
¶ 2. Disassembly steps:
¶ Step 1: Turn off the printer
Before disassembly, please turn off the printer and disconnect the power supply to ensure safe operation.
¶ Step 2: Remove the teflon tubes
Return the filaments inside the print head to ACE Pro, then pull out the four teflon tubes.
¶ Step 3: Remove the print head cable
Use an S1.5 Allen key to unscrew the two screws holding the print head cable in place, then remove the print head cable.
¶ Step 4: Remove the print head module
Use an S2.5 Allen key to unscrew the four screws holding the print head module in place, then remove them from the bracket.
¶ 3. Installation steps:
¶ Step 1: Replace the print head module
Replace the new print head module, align it with the holes in the support, and tighten the four screws holding the print head module using an S2.5 Allen key.
¶ Step 2: Install the print head cable
Insert the print head cable back into the print head module, then use the S1.5 Allen key to tighten the two screws holding the print head cable.
¶ Step 3: Install the teflon tubes
Press the black pneumatic joint and install each of the four teflon tubes back into the four-in-one-out assembly.
