¶ Tips:
Replacing the X-axis belt tensioner requires power off
¶ 1. Tools
S2.0 Allen key
S2.5 Allen key
¶ 2. Disassembly steps:
¶ Step 1: Disassemble the X-axis belt
1. Remove the X-axis belt.
¶ Step 2: Remove the X-axis belt tensioner
1. Use an S2.0 or S2.5 Allen key to unscrew the X-axis belt tensioner fixing screws.
2.The belt is removed from the X-axis belt tensioner. (Note: the spring falls off).
¶ 3. Installation steps:
¶ Step 1: Install the X-axis belt tensioner
1. Take out the new X-axis belt tensioner and pass the belt through the X-axis belt tensioner.
2.X-axis belt passes through the aluminum profile.
3.Use an S2.5 Allen key to tighten the X-axis belt tensioner housing fixing screws.
¶ Step 2: Fix the X-axis belt
1. Pass the belt through the X-axis assembly, first fix the other end of the belt on the X-axis assembly, and move the print head module closer to the other end of the belt.
2.Use an S2.0 Allen key to tighten the X-axis belt tensioner fixing screw.
¶ Step 3: Re-vibration compensation
After replacing the X-axis tensioner, vibration compensation is required again.