"Homing Failed: Y PRINTER HALTED, Please Reset" when Kobra Go Y-axis is zeroed:
¶ 1. Y-axis Limit Switch Problem
①Please check whether the Y-axis limit switch wiring is installed correctly, and whether the wiring is disconnected.
②When the machine is powered on, measure the Y-axis limit switch wiring; if the measurement is about 3V, it means that the Y-axis limit switch is the problem.
¶ 2. Motor Problem
①Please check whether the Y-axis motor cable is installed correctly and whether there is any disconnection.
②To check whether the motor is damaged, please refer to the video link below.
Video link:
ANYCUBIC 3d printer: How to Test Stepper Motor
¶ 3. Motherboard problem
If none of the above detection methods can be solved, it may be a problem with the motherboard. Please feedback the detailed investigation results to the after-sales engineer.
After-sales engineers will help you solve the problem.(Reply time :1 working day)
Please click this link to submit your ticket: