¶ Step 1: Connect ACE Pro to the printer
The connection process between ACE Pro and printer is in the unboxing video. Please refer to the unboxing video to connect ACE Pro and machine
Note: The signal line of ACE Pro is divided into 6pin and 4pin signal ports. The one connected to the printer is the 4pin port, and the one connected to ACE Pro is the 6pin port.
ACE Pro signal line ：
machine：k3 series machines
S1 series machines：
After the connection is successful, turn on the machine and check whether the ACE Pro successful connection icon is displayed on the control screen
¶ Step 2: ACE Pro feeding process
After connecting to the printer, you can load the filament normally. Open the cover of ACE Pro and put the filament in the trough. (Before feeding, check whether the filament is bent or knotted. If so, please cut off the bent part before feeding)
Put the filament in, and let go when you feel a pulling sensation, and wait for the filament to be fed automatically (it is recommended to put the filament in and wait for the filament to be fed automatically before putting in the next roll of filament, because ACE Pro can only recognize the filament that is put into the feed port first and feed it automatically at a time)
¶ Step 3: ACE Pro filament configuration information
Before inserting consumables, ace will not display consumables information.
When the consumables are being fed, ACE Pro will automatically identify the consumables with RIFD.
If the consumables do not have RIFD chips, you need to set the type and color of the consumables after feeding is completed before normal printing can be performed.
Click icon 1 to select the color of the consumables
Click icon 2 to select the type of consumables.
At the same time, the slicing software on the computer will also display the color of the consumables. Select the corresponding model and consumable type.
Initiate remote printing and select the feed port you need to print.
¶ Step 4: ACE Pro’s Material Rejection Process
Click the feed port where you want to eject the consumables, click Reject, wait for the ejection process to complete, then you can pull out the consumables and replace them.