¶ 1. Tools:
- S2.0 Allen key
- S2.5 Allen key
¶ 2. Disassembly steps:
¶ Step 1: Turn off the printer
Before replacing, please turn off the printer and disconnect the power supply to ensure safe operation.
¶ Step 2: Remove the teflon tube
Unplug the ACE Pro signal cable and power cord, then remove the teflon tube.
¶ Step 3: Remove ACE Pro case
1. Remove the four screws fastening the ACE Pro signal input board and power cover using the S2.0 Allen key.
2. Tear off the footpad and use the S2.5 Allen key to unscrew the six screws holding the ACE Pro's inner case.
¶ Step 4: Detach the ACE Pro inner shell
Use an S2.5 Allen key to unscrew the two screws holding the multicolor shell, then detach the ACE Pro inner shell.
¶ Step 5: Remove the ACE Pro motherboard
Unplug the cables from the motherboard, and use the S2.0 Allen key to unscrew the five screws that hold the motherboard.
¶ 3. Installation steps:
¶ Step 1: Replace the mainboard
Insert the cables back into the motherboard port, and use the S2.0 Allen key to tighten the five screws that secure the motherboard.
¶ Step 2: Install the ACE Pro inner shell
Install the multicolor panel, then use an S2.5 Allen key to tighten the two screws holding the multicolor panel.
¶ Step 3: Secure the ACE Pro case
1. Use the S2.0 Allen key to tighten the two screws securing the signal input board and the power cover.
2. Tighten the screws securing the cover using an S2.5 Allen key, and then glue the foot pads.
¶ Step 4: Connect the ACE Pro to the printer
Install the teflon tube, then plug the ACE Pro signal cable and power cord back into the connector.
