Before replacing, ensure the printer is turned off and disconnected from power for safety.
① Use S2.0Allen key to remove the screws securing the casing of the fixed resin vat.
② Disconnect the connectors linking to the resin vat.
① Use S2.0Allen key to remove the screws securing the cover.
② Unplug the labeled connectors from the mainboard and remove the screw securing the grounding wire using a 2.0Allen key.
① Use S3.0Allen key to remove the 10 screws securing the baseplate.
② Use S2.0Allen key to remove the upper screws securing the power interface.
③ Pull out the connection cable and separate the printer base.
①Use an S2.5Allen key to unscrew the fixing screw of the cable baffle and remove the baffle.
②Use an S2.5Allen key to unscrew the remaining fixing screws on the lens.
③Replace the new lens and install it using an S2.5Allen key.
④Use an S2.5Allen key to install the fixed cable baffle.
Install the printer base, and pass the mainboard and resin vat connector cables through the reserved holes.
① Reconnect the mainboard connector plugs and FPC ribbon cables to the mainboard.
② Use S2.0Allen key to secure the grounding wire to the mainboard.