① Rotate the plum blossom handle of the material box counterclockwise, unscrew it and remove the material box.
②Wear gloves, turn the printing platform knob counterclockwise to loosen, and then remove the printing platform.
③Pour the resin in the box back into the resin bottle through the funnel.
④ Use alcohol and paper towels to wipe the residual resin on the printing platform and material box, wipe them clean and set them aside for subsequent packaging.
① Unplug the connecting cable plug and feeding tube first to ensure safe operation.
②Use an S2.5 Allen key to remove the fixing screw and remove the automatic feeding device.
③Remove the WIFI antenna.
In the main interface, click "Tools" - "Move Z Axis" - "Z Axis Zero Point". Allow the boom to lower to the bottom position for subsequent boxing.
Press the power switch on the back of the machine to turn off the device, then unplug it. Set aside for later packing.
Accessories in the tool box include funnel filter paper, box plum blossom handle*2, S2.0/2.5/3.0 Allen key, USB flash drive, mask, gloves, film application auxiliary tool kit, plastic blade, metal blade, and equipment power cord , air purifier, automatic feeding device, Photon Mono M7 Pro instruction manual and other tools.
① Take out the box and foam retained during unpacking.
② Take out the protective foam of the air purification and automatic feeding device, and install the air purification and automatic feeding device into the foam. After finishing, put it aside temporarily, waiting for the subsequent steps to pack other accessories, and then put them into the corresponding locations.
③Pack the foam, machine, machine accessories, and tool boxes one by one in the order shown in the picture below, and finally use tape to pack the cartons.