Length/width/height: 196.7mm 122.8mm 200 mm
405nm common rigid resin, dental non-cast resin, dental cast resin, plant based resin
Z-axis: 0.01mm XY according to the screen pixel (different models vary) Mono X2 48um 4096*2560 (4K)
Printing speed Max 60mm/h
If you do not need to continue printing the model, shut down the machine and recycle the resin into the resin bottle through the filter funnel (failure to do so may damage the exposure screen in the next printing).
Wear a mask and gloves (resin should not contact the skin directly), and do not exceed the maximum scale line (MAX line) when pouring resin into the box.
3.5 inch resistive touch screen
The recommended ambient temperature is 8 ° C to 40 ° C, and the humidity is 20% to 50%. Avoid direct sunlight
When the machine works as a whole, the volume generated is about 60 decibels below, and the sound is small
The curing time of different resins is different, the exposure time needs to be adjusted, and the RERF file can be printed to determine the relative optimal curing time of the resin
Grease the screw regularly, apply anti-rust oil to the guide rail, and replace the release film regularly (release film service life is 30,000 layers)
Use the spatula knife to slowly remove the model from the edge at a 45° Angle
The problem is likely to be caused by the new printing platform and the long exposure time at the bottom
1.Reduce the exposure time at the bottom before printing, and adjust the actual situation according to the degree of model accessibility and previous printing parameters.
2.Adding a bottom valve at the bottom of the model will facilitate the model to be taken out.
3.Reduce the number of layers
1.This problem is probably caused by the USB flash drive itself, please format the USB flash drive to FAT32 format, or replace a USB flash drive within 8GB. It is recommended that the file name consist of English and numbers and avoid special characters.
2.Please make sure the slicing file format is correct. Photon Mono X2 recognizes slicing file names with a.pmx2 suffix
1.The exposure time of the bottom layer is insufficient, please increase the exposure time
2.The contact area between the bottom of the model and the platform is small, so the bottom valve needs to be added
3.The level is not adjusted well (the first layer of the print is too high, or the platform is high on one side and low on the other)
Please apply the appropriate amount of grease to the lead screw, and control the motor to run up and down several times to make the grease evenly attached. Please try to avoid the use of lubricating oil, strong fluidity of lubricating oil will flow along the motor rod into the motor.
First restart the printer, and then disassemble the control screen cable and buckle are loose. If it is not loose, replace the control panel.
If the above steps do not provide assistance or if you encounter any other issues during subsequent use, we recommend that you create a support ticket.
The after-sales engineers will assist you in finding a solution to the problem(Reply time :1 working day)
Please click this link to submit your ticket: