¶ Tip：
1.Replacing the solenoid valve requires power off.
2.Drain the liquid in the barrel before replacement.
3.When replacing the solenoid valve, a small amount of liquid may flow out of the tube.
4.Wash&Cure 3 Max has four solenoid valves, which can be replaced as needed.
¶ 1. Required Tools
S2.5 Allen Key
S4.0 Allen Key
Replacement accessories: Solenoid valve*4
¶ 2. Disassembly process
¶ Step 1: Remove the water pipe on the back of the machine
Go to the back of the machine, press the gray buckle and pull the water pipe outward at the same time, and remove all the water pipes one by one.
¶ Step 2: Remove the bottom cover
① Place the machine on the side with the "ANYCUBIC" logo facing up. (Please note that when the machine is placed, a small amount of water may leak out of the drain port at the bottom. You can place a piece of cloth at the bottom in advance to prevent this from happening.)
②Use an M2.5 Allen Key to unscrew the 8 screws that secure the bottom case of the machine.
③Use an M4.0 Allen Key to unscrew the 4 screws that secure the bottom case of the machine.
¶ Step 3: Disassemble the solenoid valve
1. First remove all blue clamps that secure the water pipes.
2. Use an S2.5 Allen Key to remove the six screws that secure the solenoid valve, and then remove the fixing bracket.
3. Then bend the water pipe here and remove it.
4. Press the safety valve on the connector with one hand and pull out the water pipe with the other hand.
Then remove the water pipe from the other connection.
5. Remove the solenoid valve from the connector and then remove the cable from the solenoid valve.
¶ 3. Installation process
¶ Step 1: Install the new solenoid valve
Connect the new cables in order.
Then insert the solenoid valve into the corresponding pipe port
¶ Step 2: Connect the water pipe
Connect the double-tube head to the solenoid valve connection port and check whether it is inserted to the bottom.
Then install the top water pipe in place
Put all the blue snap rings back in place
Use an S2.5 Allen Key to secure the six screws between the bracket and the solenoid valve.
¶ Step 3: Install the bottom cover
1. Lay the machine on its side and use an S2.5 Allen Key to unscrew the bottom cover fixing screws.
2. Use an S4.0 Allen Key to unscrew the bottom cover fixing screws and remove the bottom cover.
¶ Step 4: Install the water pipe
Go to the back of the machine and insert all the water pipes one by one. (Note: The water pipes need to be inserted to the bottom. If they are not inserted to the bottom, there may be a risk of water leakage.)