Length/width/height: 305mm * 165 * 300mm
There are automatic cleaning (AUTO), and separate cleaning (WASH)
The default total duration is 15 minutes and 30 seconds, and only the cycle time of the cleaning agent cleaning can be changed during the process (13 minutes-42 minutes and 30 seconds)
The default total duration is 12 minutes and 30 seconds. During the process, only the cycle time of the cleaning agent can be changed (10 minutes-39 minutes and 30 seconds).
The default total duration is 3 minutes, and the user can adjust 30S-30 minutes.
The overall rated power of the machine is 120W
Switch to CURE mode, the default duration is 3 minutes. You can press "-" and "+" to adjust the curing time, and then click START/PAUSE
Click AUTO, then click START/PAUSE, and the default 15 minutes and 30 seconds of automatic cleaning and curing will be performed. During this period, you can click START/PAUSE to pause, or click CANCEL to reset.
1. In the working state, you need to click START/PAUSE first, then click CANCEL to respond. To ensure safety, the machine will stop after running the system-specified process.
2. In the non-working state, long press CANCEL to reset the discharge.
1. Restart the machine, click AUTO or CURE, and confirm whether there is any sound when touching
2. If there is still no sound after the above actions, the buzzer may be broken and the
motherboard needs to be replaced
The recommended ambient temperature is 10℃-40℃, humidity is 20%-50%, avoid direct sunlight
When the machine is working as a whole, the volume generated is about 60 decibels
If not used for a long time, use clean water to run the entire process in AUTO, clean the bucket, press and hold the CANCEL button to drain the water, and wipe the water in the machine with a dry rag.
Report E11 may be due to lack of water in the water bucket or lack of detergent in the cleaning bucket. After filling it, click START/PAUSE to continue the previous process.
After the model printed with water-washable resin is rinsed with water and air-dried, it is cured using the single curing mode.
405nm