Tips:
Replacing the Core X module requires power off
S2.0 Allen key
S2.5 Allen key
Kobra S1 shell disassembly guide:
1. Remove the front shell of the print head and remove the fan plug.
2. Use the S2.0 Allen key to unscrew the fixing screws of the rear shell of the print head.
3. Remove the blue buckle, press the black press head and remove the feed tube upward.
1. Remove the wire harness of the material break detection board, the wire harness plug of the cutter detection board, the wire harness plug of the print head, and the wire harness plug of the hot end of the print head.
2. Remove the wire harness stuck in the extruder from the buckle.
3. Use the S2.0 Allen key to unscrew the fixing screws of the extruder module and remove the extruder module.
1. Use an S2.0 hex wrench to unscrew the screws that fix the top frame and the fixing plates on both sides.
2. Remove the XY limit switch line and camera line.
1. Use an S2.0 hex wrench to unscrew the XY axis assembly fixing screws.
2. Use an S2.0 hex wrench to unscrew the XY axis assembly fixing screws
3. Take out the XY axis assembly upwards.