Open the "Anycubic" APP, scan the code and bind the printer according to the instructions below.
Kobra 3 Combo-Printer Binding Guide | Anycubic Wiki
Insert the USB flash drive into the printer's USB port, then follow the instructions below to install the camera.
Kobra 3 Combo-Camera Installation Guide | Anycubic Wiki
(1) Open the "Anycubic" APP, click "Workbench", then select the Kobra 3 page, click "Print" to initiate the print task.
(2) Select the file you want to print, check "Timelapse" on the page that initiates printing, and then click "Start Now".
After printing, remove the USB flash drive from the printer, then insert the USB flash drive into your computer and click on the Time-lapse-Video folder to view the video.
If there is no video in the folder, first check whether the USB flash drive is loose or removed during printing.
Then check whether the camera wiring is loose, and whether the printed page can monitor the printer.
Note: The time-lapse photography feature of the printer must ensure that the USB flash drive and camera are connected to the printer before printing.
If both the USB flash drive and the camera are connected to the printer properly, please check the printer's network connection by following the guidance document below.
Kobra 3 Combo-The device cannot connect to the network | Anycubic Wiki
If the above steps do not provide assistance or if you encounter any other issues during subsequent use, we recommend that you create a support ticket.
The after-sales engineers will assist you in finding a solution to the problem(Reply time :1 working day)
Please click this link to submit your ticket: