The Anycubic Wash & Cure 3 Plus features a brand-new arrangement of lamb beads combined with a lens light source. Compared to the previous generation Anycubic Wash & Cure Plus, it offers a 20% improvement in curing uniformity*. This results in a more thorough and comprehensive overall curing of the model, ensuring better quality and consistency.
Official product page: Anycubic Wash&Cure 3 Plus
¶ User Manuals
¶ Product Details
¶ Troubleshooting
¶ The machine does not work.
- Poor power contact. Pull out the power cord and plug it in again.
- The anti-UV cover is removed in the cung process. Please put on the cover.
¶ The rotor inside the washing bucket does not rotate during the washing process.
- The rotor is stuck by foreign matter. Stop washing, pour out the solvent and remove the foreign matter.
- There are too much precipitation in the washing solvent. Stop washing, drain the solvent and clean the precipitation.
¶ The machine has abnormal sound during operation.
- The ground where the machine is placed is not flat enough.
- The screw on the rotor is loose. Tighten the screw.
¶ Part of print objects are white after wash and cure.
- The concentration of the alcohol which is used for washing is not high enough, Use alcohol with concentration exceeding 95%.
- The printed obiects are cured immediately after washing. Please air dry them before curing.
¶ The mode lights are not lit when you touch the mode button.
- Try again or reboot the machine.
¶ Maintenance
¶ Recycling of detergent
The solvent in the washing bucket might become muddy after long-time washing. The solvent can be recycled through the following treatment.
lt is recommended to dispose or replace the solvent after washing 30 models to ensure the washing effect.
- Allow the washing solvent stay still for over 10 hours so the residue could be precipitated and settled.
- Filter the top layer of solvent and pour it into another container. Then, seal the container.
- Expose the residue in the sunlight, Then, the cured resin can be handled as general solid waste.
¶ Clean the rotor
The rotor may rotate abnormally after long-term use, you can remove the rotor from washing bucket to clean it.
Please take off the washing bucket from the base and drain the solvent before cleaning.
- Remove the rotor at the bottom of bucket and then clean it.
- Install the rotor.
¶ Mainboard
¶ Motor
¶ Download Center
¶ Manual
- Anycubic Wash & Cure 3 Plus_User Manual_v0.0.2_EN
- Anycubic Wash & Cure 3 Plus_User Manual_v0.0.2_DE
- Anycubic Wash & Cure 3 Plus_User Manual_v0.0.2_IT
- Anycubic Wash & Cure 3 Plus_User Manual_v0.0.2_FR
- Anycubic Wash & Cure 3 Plus_User Manual_v0.0.2_ES
- Anycubic Wash & Cure 3 Plus_User Manual_v0.0.2_JP
- Anycubic Wash & Cure 3 Plus_User Manual_v0.0.2_RU