Photon Mono M7 Max adopts LighTurbo 3.0 optical design, COB light source + Fresnel lens + mask technology to achieve uniform purple light irradiation within a small angle of 3°, ensuring that the 13.6-inch 7K black and white screen is free of stray light interference, making the printed model consistent across the entire width.
Intelligent Release 2.0: The traditional fixed lift height may cause some details to fail to completely release, resulting in large model faults. The model release peeling force is detected through self-developed intelligent algorithms and mechanical sensors, and the lifting height of the printing platform is dynamically adjusted for each layer of the slice model according to the slice model to ensure a higher success rate of the model. Dynamic light-off compensation: The resin reflow status is monitored through mechanical sensors, and the newly upgraded speed regulation function is used to dynamically adjust the light-off time of each layer according to the slice model data, so that the exposure surface of each layer can be accurately exposed.
¶ User manual
¶ Product details
¶ Printer manual
¶ Parameter settings
In normal printing mode, it is recommended to set the layer height to 0.05mm, and other settings are:
In fast printing mode, it is recommended to set the layer height to 0.1mm, and other settings are:
¶ Troubleshooting
- M7 Max-FAQ
- Printing effect is not good
- Cannot recognize USB flash drive
- Model does not stick to the printing platform
- Printer binding guide
- Firmware update guide
- Printer cannot connect to the network
- Abnormal pop-up window guide
- Force sensor calibration guide
- Z-axis limit switch not working properly guide
- Auto-Fil Unit abnormal
- Z-axis motor abnormal noise
¶ Device abnormal pop-up window
¶ Maintenance
¶ Printer cover
¶ Strain gauge
¶ LCD screen
¶ Motherboard
¶ UV lamp module
¶ Control screen
¶ Switch power supply
¶ Fresnel lens
¶ Z axis
- Photoelectric limit switch replacement guide
- Z axis motor replacement guide
- Z-axis guide rail replacement
¶ ACF film
¶ Download-Center
¶ Firmware
- M7 Max firmware update guide
- 4.0.9.8 version firmware update content:
1. Upgraded heating function during printing.
2. Upgraded automatic resin calibration.
3. Optimized various user experiences. Please upgrade to the latest version 4.0.9.8.
¶ Manual
¶ Photon Workshop V3.3.2
¶ Software
¶ User Manual
- Anycubic Phtonworkshop User_Manual_EN
- Anycubic Phtonworkshop User_Manual_DE
- Anycubic Phtonworkshop User_Manual_FR
- Anycubic Phtonworkshop User_Manual_ES
- Anycubic Phtonworkshop User_Manual_JP
- Anycubic Phtonworkshop User_Manual_IT
- Anycubic Phtonworkshop User_Manual_RU
- Anycubic Phtonworkshop User_Manual_ZH